E-mail: sales@ykhaotai.com
Tel: +86-579-89297068
Contact Us

Zhejiang Hecheng (Hechin) Electric Technology Co.,Ltd

Address:No.8 Yunzhong Road, Baiyun Industrial Area, Yongkang 321300, Zhejiang, PRC.








Home > News > Content


Slide Plate Out

May 07, 2016

When pressed, slide out of the adhesive tape from the steel plate, especially when pressed epoxy-phenolic glass cloth laminated board prone, commonly known as "running." Responsible for running more, such as tape glue than tender, adhesive on both sides is uneven, uneven material, charging is not straight, pre-heat glue pressure is too high and force the hot plate itself will have a running phenomenon, running can cause equipment failure, be sure to avoid. Use the same cloth with adhesive in preparation, consistent resin content and soluble basic billets, Joggle, Pack, rising pressure. If running, close the steam temperature, but keep enough pressure, observed slipping out and stay stable after adjustment, and then gradually to the steam heating continued repression.

Previous: No Information

Next: Voltage Failure